Touch Screen controller for RGB LED strips factory supplier

JCY-001 Exterior Size
 114mm×56mm×22mm
JCY-001 Function Describe
There are 5 press-keys and a touch color ring for the telecontroller.
5 press-keys as follow:
1Key-press of the switch: red key, switch on or switch off.
2 Color lighting: control the lamp into the color lighting mode, press 3 seconds, it can control the lamp into the color shading mode, the light can change the color automatically
3 White lighting: control the lamp into the white lighting mode.
4 Turn up the light: it can control the brightness increase of the lamp in any modes, it can increase one grade after pressing one time, the total is 8 grades.

5 Turn down the light: it can control the brightness reduction of the lamp in any modes, it can reduce one grade after pressing one time, the total is 8 grades.

Touch color ring

Touch color ring is a  high reliability touch inductor, it can reliably distinguish the location of the color ring, and only be effective for the body fingers. In the color mode, when the finger touch  the  corresponding colo, it will control the lighting light give off the corresponding color.

When the automatic demonstration mode is being, the brightness adjusting can use normally,if exiting or keep the current color,press the color press-key, it will exit the automatic demonstration mode, and keep the current color.

Product Parameter

1Case material:  ABS+PC

2Input Voltage1.5V*3  AAA battery

3Power consumption of the standby: max 100uA,normally, a set of new batteries can be used 9-12 months

4Wireless frequency433.92MHz, all integration chips design,can pass the FCC certification

5Emission powerless than 10mW

6Mating telecontrol distanceopen area 20-30M.

Points for attention:

1When changing the batteries, please keep 10 seconds not to touch the color ring or use the palm to cover the